Toyota GR Corolla Carbon Guards 2022-2025

Batch 1

Megachip™ splash guards are track-ready while subtle enough for daily driving. These provide invaluable protection to the paint behind the wheels and along the sides of the car. The front guards have a 1/2" width adjustment for stock wheels or wider setups. 

Megachip carbon guards are engineered with aerodynamic performance, extreme durability, and a seamless fit and finish. 

Testing was performed using computational fluid dynamics (CFD) to simulate aerodynamic performance of the guards specifically on the GR Corolla. The left-hand (driver's) side of the car is stock, while the right-hand side has Megachip guards.

Fig 1: air velocity on horizontal plane with and without guards

The results from the analysis indicate a measurable, but negligible, increase in drag.

Below is a photo showing the the pressure increase near the Megachip guards. Air velocity is approximately 100 MPH approaching the car:

Fig 2: air pressure differences with and without guards

Air direction / deflection are visualized in the following pictures, one without Megachip guards and one with them:

Fig 3: Air pressure without guards; vertical plane

Fig 4: Air pressure with guards; vertical plane

Fig 5: Results during 60-simulation analysis

The graph shows consistent results during a sequence of simulations: there is a very small increase in drag coefficient with Megachip guards. However, it is important to note that software results do not always align perfectly with real-world outcomes. The result is a splash guard taken to the highest degree of quality and design, making it extremely competent on the track and in the showroom.

Details:

• 1.25 mm thick, 2x2 twill weave, gloss finish carbon fiber is hand-laid and autoclave-cured

• Drastically reduces rock chips and splashing along the sides of the fenders, doors, and rear bumper. Drive with confidence on rough pavement, through construction sites, and off-road settings

• Functional in all weather conditions including reducing spray from snow and salty slush

• Installation takes 15 minutes

• Engineered and tested specifically on Limit+1's GR Corolla for extensive Midwest Winter driving and track testing
• Aerodynamically optimized using CFD analysis

• No drilling, vehicle modifications, or aftermarket hardware required

• Installation instructions included

• Assembled in the USA with USA materials

What's Included:

• 4x Megachip guards
• 4x Alcohol prep pads
• 2x Adhesion promoter pads
• 2x Washers for front guards
• New rear pop clips
• Installation instructions
• Guaranteed satisfaction